This interactive epoxy floor coating selector helps you choose the correct epoxy system based on traffic level, chemical exposure, concrete condition, and downtime requirements.
If you’re comparing epoxy vs tiles vs mats, use this guide instead:
Epoxy vs Tiles vs Mats.
Choose the closest match for your floor. Your recommendation updates instantly.
(ArmorGarage manufactures and ships products nationwide.)
If you’re unsure which option fits, pick the “worst-case” condition (oil or moisture) to avoid adhesion failures.
Also see our new 2026 Garage Floor Coating Guide
Select options to see your best match.
Always add 10% safety factor to the actual square footage of your floor. Better to have a little extra than run short because your floor was more porous or rougher than normal. If in doubt about how much protection you need, always overrate your epoxy and never underrate it.
| Type | Best Use | Pros | Watch Out |
|---|---|---|---|
| True 100% Solids Epoxy + Topcoat | Most garages & long-term ownership | Best value over time, thick build, excellent adhesion when prepped correctly | Needs proper prep + cure time, 2-3 days |
| Fast-Cure Systems | Return-to-service is critical | Faster install windows | Short pot life, tricky to work with |
| Novolac / Chemical-Resistant | Acids/solvents, harsh chemical exposure | Very high chemical resistance | Not for residential use |
| Flake Broadcast Systems | Decorative + easy to apply + durable | Hides imperfections, popular garage look | Not recommend where small parts may drop on the floor |
| “One-Coat / Water-Based” Kits | Very light duty only | Lower upfront cost | Common peeling/wear-through in garages |
Not sure epoxy is right for your project? Compare all three garage flooring types here: Epoxy vs Tiles vs Mats.
If epoxy fails, it’s usually one of these: poor prep, moisture, contamination, or using a low-quality coating.
Need help choosing quantities and the right system? Call 866-532-3979 or email info@armorgarage.com.
For most garages, the best choice is a true 100% solids epoxy paired with a urethane topcoat. This combination balances cost, durability, adhesion, and long-term wear.
Yes when you want a long-lasting floor. It typically builds thicker, bonds better (with correct prep), and holds up longer than many low-solids or water-based kits.
The most common causes are insufficient surface prep, moisture/vapor pressure, or contamination (oil/grease). Lower-quality coatings increase failure risk.
Lifespan depends on prep, traffic, and the coating system. Higher-quality systems with correct prep and protection can last for many years. If the topcoat wears, it can often be renewed by scuffing and recoating.
You must create a proper surface profile for epoxy to mechanically bond. This is typically done by grinding or etching, depending on the floor condition and the system you choose.
For harsh chemical exposure, use a chemical/acid resistant epoxy designed for that environment. Match the product to the chemicals present. See: Acid & Chemical Resistant Epoxy.
Choose a fast-cure system designed for quick return-to-service. See: Ultra Fast Setting Epoxy.
Glossy coatings can be slick when wet. If slip resistance matters, choose a system designed for traction or add the correct anti-slip aggregate/topcoat options. See: Non-Slip Epoxy Systems.
Yes, but the floor must be properly cleaned and profiled, and heavily contaminated concrete may need special prep steps. When in doubt, contact ArmorGarage with details/photos of the floor so we can recommend the right system.
Moisture must be addressed first. A moisture-sealing system may be required to reduce peeling/blistering risk. See: Moisture Sealing Epoxy.
No. ArmorGarage sells and ships epoxy coatings and kits nationwide. We support DIY customers with product selection, quantities, and application guidance.
